2026 Toyota RAV4 Dash Cam Installation

A Simple, Custom-Fit Install — Made for Your 2026 RAV4.

Remove the original cover, connect the power adapter, and fit XPRO into place. No drilling, cutting, wire splicing, or fuse-box wiring is required for the standard driving installation shown.

This guide covers the XPRO installation for the 2026 RAV4. Use the XPRO housing and power adapter made for your vehicle.

---

Three Installation Steps

1. Remove the Original Cover

Use a trim tool to gently release the clips and remove the factory cover behind the rearview mirror.

Remove the smaller cover around the mirror stem to access the connection underneath. Keep the original trim pieces ready for reassembly.

2. Connect the Power Adapter

Unplug the factory sensor connector shown in the video, then connect the matching ends of the XPRO adapter between the original plug and sensor.

Make sure each connection is secure, and tuck the wiring neatly inside the housing area.

No power cable needs to run down the windshield or A-pillar for standard driving recording.

3. Fit XPRO and Refit the Cover

Position XPRO around the mirror stem and align it with the original mounting points. Press it securely into place, then refit the original upper cover.

Make sure all clips are engaged and no wires are trapped between the panels. Switch on the vehicle and confirm that XPRO powers on and records correctly.